Product Description
There are many areas within the home that are more susceptible to fires than others. These high-risk areas exist where, statistically, fires ignite more frequently due to the additional production of heat, such as electrical wiring, attic spaces, fire places, etc. HOT SPOT HOME FIRE GARD can be used on wood surfaces in these areas for greater protection against the ignition or development of flame.

USES: Use HOT SPOT HOME FIRE GARD on wood surfaces in the home, especially around dryer vents, electrical panels and outlets, garage interiors, attics, chimney flues.

Shake well before each use. Always test an inconspicuous area before spraying entire surface area. Do not intentionally attempt to test burn treated areas. Remove cap and foil seal. Pour HOT SPOT HOME FIRE GARD into a paint tray or old clean container. Using a paint or sponge brush, apply an even coat generously across the entire surface until damp. Do not apply directly on metal surfaces or on electrical connections. Allow treated area 12 hours to dry at room temperature. Use on any porous surface. Must be reapplied after laundering. For best results, reapply annually.

It is a violation of federal law to use this product in a manner inconsistent with its labeling. Do not intentionally attempt to test burn treated areas. Shake well before each use.

NO-BURN® HOT SPOT HOME FIRE GARD is a highly effective aid in case of fire, however NO-BURN® North America, Inc. cannot warrant that the product will suppress all fires. Before using, the user agrees to assume all risks and liabilities in connection with its application, use and/or storage. Sellers and manufacturers only obligation shall be to replace any NO-BURN® HOT SPOT HOME FIRE GARD found to be defective within one year from the date of purchase

PROTECT FROM HEAT AND FREEZING WHEN STORING Note: This product must be stored between 40°f and 80°f